Medion DISNEY CLOCK RADIO User's Guide

1QUICK REFERENCESlide to select AM or FMRotate to set the radio stationSlide to select the alarm (AUTO: Radio or BUZZ: Buzzer) or to turn the unit ON

10OPERATIONAdjust the volume using the Volumecontrol ❶. Slide the AUTO/BUZZ/ON/OFF switch 2 to the OFFposition to turn the unit off. 213Slide the AUTO

11OPERATION (CONTINUED)Rotate the Clock/Alarm Time Setknob on the rear of the unit until theAlarm hand points at the desiredalarm hour.11TO SET OR RES

12OPERATION (CONTINUED)Set the alarm time as previouslyinstructed. Select a radio station asdescribed on page 10 and make surethe Volume control is s

13OPERATION (CONTINUED)Set the alarm time as previouslyinstructed. Make sure the Volumecontrol is set as desired.NOTE: Make sure the volume is notat m

14OPERATION (CONTINUED)TO SHUT THE ALARM OFFSNOOZETo shut the alarm off, slide theAUTO/BUZZ/ON/OFF switch to theOFF position. Slide theAUTO/BUZZ/ON/OF

15TROUBLESHOOTING GUIDEShould this unit exhibit a problem, check the following before seeking service:SYMPTOMPOSSIBLE POSSIBLECAUSE SOLUTIONRADIONo so

2QUICK REFERENCE (CONTINUED)TO LISTEN TO THE RADIO:1. Slide the AUTO/BUZZ/ON/OFF switch to the ON position to turn the unit on. 2. Slide the Band swit

3SAFETY PRECAUTIONSDANGEROUS VOLTAGE:The lightning flash with arrowhead symbol within an equilateraltriangle is intended to alert the user to the prese

4SAFETY PRECAUTIONS (CONTINUED)• Place the unit on a stable surface.• Avoid installing the unit in locations described below:• Places exposed to direc

5IMPORTANT SAFETY INSTRUCTIONSBefore using the unit, be sure to read alloperating instructions carefully. Please notethat these are general precaution

6IMPORTANT SAFETY INSTRUCTIONSpoint where they exit from the appliance.13. LIGHTNINGTo protect your product from a lightningstorm, or when it is left

7LOCATION OF CONTROLS101197861234512131. Left Speaker2. Right Speaker3. AUTO/BUZZ/ON/OFF Switch4. SNOOZE Button5. Band (FM/AM)Switch6. Minute Hand7. H

8POWER SOURCESCLOCK OPERATIONTo operate the clock, one (1) AA battery must be installed as follows:1. Remove the batterycompartment door on thebottom

9POWER SOURCES (CONTINUED)AC OperationTo operate the unit using AC power, connect a 4.5V DC, 500mA ACadapter with positive center (included) to the DC