Medion GoPal User Manual download pdf (Page 11)

GoPal Navigator 6

Chapter 2: Basics of operation

Your navigation device is ready to operate immediately: The navigation software and the map ma-

terial included have been pre-installed on your device. After starting the device you must then se-

lect the language within the software. The following message will then be shown:

 Information on road traffic regulations and operation during the journey

The instructions for the navigation system are recommendations only: Always pay attention to

road traffic regulations.

For safety reasons, entries may not be made by the driver whilst driving: Please make the nec-

essary entries before beginning the journey. If you need to change your entries during the jour-

ney, stop your vehicle at a suitable point (parking spot etc.).

You must accept this information by tapping the

button. If you decline the information using

the

button, further use of your navigation software is not possible.

Then the following options are available:

 A short briefing on setting up your navigation device is available via the Short introduction but-

ton: mounting in a vehicle, navigation of the software, entering destination data, operation via

voice command (if available for your device) etc. is described here.

 You can start the settings assistant to configure the basic settings of your navigation software

using the Settings assistant button (see Settings assistant

The main menu of your navigation software can be accessed via the Start navigation directly

button (see Chapter 3: Operating the GoPal® navigation software

). However, in order to enter your

own navigation destinations and user-specific settings, you must be familiar with the basic operat-

ing concept of your navigation system, which will be presented to you on the following pages. If

you are already familiar with the operating concept, please go directly to Chapter 3: Operating the

GoPal® navigation software.

Your navigation system features two operating modes: "menu view" and "map view".

Operation in the menu view

All of the software functions are organised in hierarchical menus which are called up by pressing

the buttons on the screen (touchscreen) of your navigation device.

Each button opens up the menu level underneath. If a button has not been assigned to another

menu level, the function is performed directly.

Within the menu levels you can use the available buttons to open up or exit other sub-menus.

Navigation within the menus is as follows:

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 81 82

No comments

Medion GoPal User Manual Page 11