Medion GoPal User Manual Page 81
- Page / 82
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Installation and start-up using the GoPal
®
Assistant
Formatting the external memory card
In the volume area, the GoPal
®
Assistant gives you the option to format an external memory card
located in either the MMC/SD card slot of your navigation device, a card reading device or a USB
stick connected to the PC. It is, however, only possible to format a memory card inserted into the
navigation device if the connected navigation device is recognised as the current device. If you
switch navigation devices while operating the GoPal
®
Assistant you must first activate the con-
nected device. Proceed as follows:
1. Select the connected device identified by the green button in the Devices area.
2. Left click on Switch to this Device. If this button is not available, the connected device has al-
ready been recognised as active.
Once the navigation device has been recognised as the currently connected device, proceed as
follows to format the inserted memory card:
1. In the volume area, select Current device name/External Storage via the Selected Volume
pop-up menu.
2. Now left click on Format.
3. The Format Volume dialog box appears: Left click on OK to begin formatting the memory card.
To cancel the process, select the Cancel button.
4. The GoPal
®
Assistant performs the formatting and then displays a message that the formatting
has been completed successfully: Left click on the OK button to close the message.
Tip
External memory cards in a card reading device and USB sticks can be se-
lected from the Selected Volume menu and formatted at any time.
The available memory is displayed in the Memory Status area via the entries and the progress bar
once formatting is complete.
Shopping in the GoPal shop portal
With the Store button the GoPal
®
Assistant provides direct access to the GoPal shop portal: In this
online area you can purchase optionally available data packs such as additional map material or
POI data and transfer these to your navigation device using the GoPal
®
Assistant.
Tip
Please note that your computer must be connected to the Internet in order to
access the products on offer in the GoPal shop portal.
After you have tapped the Store button, the GoPal shop portal is opened. You need to register be-
fore you can use the shop portal: to do so, enter your mail address along with a password of your
choice in the welcome dialogue box. After you have entered this information the store will be acti-
vated for you.
Basic operation of the GoPal shop portal is identical to the navigation in a normal Internet browser.
The following buttons are available for this along the top of the browser window:
77
- GoPal Navigator Version 6 1
- Contents 2
- Chapter 1: Introduction 5
- Introduction 6
- System requirements 7
- Conventions in this manual 8
- Tips and warnings 8
- Important information 9
- Trademarks 9
- Copyright and Warranty 10
- Operation in the menu view 11
- Basics of operation 12
- Operation in the map view 13
- Main menu 15
- Manual destination entry 16
- Enter address 17
- Entering the street name 18
- Home address 19
- Choose from last locations 20
- Search for point of interest 20
- Choose from favourites 21
- Calling up a favourite 22
- Deleting all favourites 22
- Editing favourites 22
- Operating the GoPal 23
- navigation software 23
- Optimising the route 24
- Changing a planned route 25
- Starting a planned route 25
- Destination from map 26
- Enter coordinates 26
- Load tour 27
- Traffic conditions 32
- Route information 33
- Avoid route 33
- Route simulation 34
- Directions 34
- Stop route guidance 34
- Travel statistics 34
- Compass 35
- Plot GPS track 36
- Save current position 36
- GoPal Navigator 6 37
- Adapting the route 38
- Adjusting the settings 39
- Adapting the map 42
- Adapting the POI settings 46
- Adapting the volume 46
- Adapting the power options 49
- Adapting the TMC settings 52
- Security 53
- FM transmitter 53
- Factory settings 54
- Voice command in main menu 58
- Route options 63
- Language and keyboard 65
- Points of interest settings 65
- Warnings and driving safety 66
- Time and units 66
- Energy options 66
- Display settings 67
- Settings assistant 67
- Initial operation 68
- Installation via memory card 69
- Transferring additional data 70
- Assistant 72
- User interface of the GoPal 73
- Volume area 74
- Setting the user language 75
- Management of GPS Tracks 78
- Changing the device name 80
Related products and manuals for Car navigation systems Medion GoPal
(96 pages)
(98 pages)
(96 pages)© 2020, manymanuals.com. All rights reserved. | 2.563 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals