Medion GoPal User Manual download pdf (Page 68)

GoPal Navigator 6

Chapter 6: Manual installation and

start-up

When delivered, the navigation software and the map data for different countries (depending on

the version) are usually pre-installed on the device and/or the memory card included in delivery. If

that is not the case, you must first install the navigation software as well as the map material nec-

essary for route planning before operating your navigation system.

If you are updating or would like to install subsequently purchased navigation software or addi-

tional maps or POI files to your navigation device, you must remove individual or all data installed

on your device before installing the newly purchased software. The following data can be manually

installed by the user:

 GoPal

Navigator navigation software

 Map material in the form of PSF files

 Point of interest data (POI data) in the form of PSF data

 Voice recognition data in the form of TSD data (depending on device)

Tip

Even though it is possible to install files manually, we recommend that you

use the GoPal

Assistant supplied with the software to transfer and update

software components on your navigation system. Chapter 7: Installation and

start-up using the GoPal® Assistant describes the installation and data ex-

change using the GoPal

Assistant.

The manual transfer of software components from CD/DVD to your mobile navigation device takes

place in Windows Explorer on your PC. Select one of the two following methods to exchange data

between your navigation system and your PC:

 If you have installed the Microsoft ActiveSync

software from a CD/DVD, you can connect your

navigation device directly to the USB port of your PC using the USB cable supplied in order to

synchronise the desired data. In this case, you have direct access to the internal flash memory

of your navigation device.

 If your PC has a card reading device, you can insert the memory card supplied directly and

manually move the data in the file explorer. In this case, you do not have direct access to the in-

ternal flash memory of your navigation device.

Initial operation

Depending on the version of your navigation system, the software necessary for operation may not

have been pre-installed on your navigation device and can instead be found on the memory card

supplied: an appropriate comment indicating this can be found in the readme file as well as on the

packaging of your navigation device. In this case, you must install the software to operate your

navigation system.

Proceed as follows to install:

1. Carefully remove the memory card from its packaging. Take care that the contacts are not

touched or contaminated: Otherwise data transfer may no longer be possible.

2. Insert the memory card into the memory card slot of your navigation device until you hear a

click.

3. Switch on the navigation device by pressing the ON/OFF switch on the device (see device

manual).

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 81 82

Comments to this Manuals

No comments

Medion GoPal User Manual Page 68

Comments to this Manuals

Related products and manuals for Car navigation systems Medion GoPal